Chibi Chihiro and Haku- Printed Images
Added 2022-04-15 14:01:51 +0000 UTC
More info and Render images here:
https://www.patreon.com/posts/65043110
Comments
Guys I had the same problem. Found that the pressuported files only can be properly sliced in Chitubox
Marina
2022-06-27 17:02:42 +0000 UTCWhat did you end up doing? It looks to me line the outer layer is too thin. Did the you make the model solid?
Cos.n.Fx
2022-05-18 02:48:12 +0000 UTCmy 1st print of this also faled on the anycubic x 6k.. but then saw that the file needs to be fixed so i put it into 3d builder and it looks like it fixed it .. it printing right now got 1hr to go and looks 100% well update when its done
2022-05-18 00:47:40 +0000 UTCinside the access folder has the following files: - Chihiro_Presuport - Printed Images - rendered images ( Turnaround, Scaling &Parts , BeautyShot - Chihiro_Haku_STL Please message us directly so we can better support you. Thanks.
nomnom
2022-05-17 07:27:14 +0000 UTCI will need to check again. When I opened the stl folder everything was pre supported and I'm getting dead pixels
Cos.n.Fx
2022-05-17 06:47:54 +0000 UTCyes, we provide just the stl on the same folder :)
nomnom
2022-05-17 06:41:53 +0000 UTCHi so I have tried 3 times to print this on my anycubic mono x and it continues to fail. Do you offer the unsupported files as well so I can see if that is the issue?
Cos.n.Fx
2022-05-16 10:03:30 +0000 UTCAmazing. I love it!
Titichu2020
2022-04-30 20:37:23 +0000 UTCThis is so fabulous I love the pose with their faces towards each other!
CRAIG JOHNSON
2022-04-16 09:14:02 +0000 UTCLove it!
Emmanuel McGrew
2022-04-15 18:22:55 +0000 UTCAbsolutely gorgeous
David Sanchez
2022-04-15 14:17:37 +0000 UTC
